![]() ![]() An In-Sight vision system can be triggered by directly manipulating the Trigger Enable and Trigger bits in the RY Block, or by monitoring the Trigger Ready, Trigger Ack and Missed Acq bits in the RX Bit Block.For more information, see Online/Offline. Place the In-Sight vision system Online.Set the Trigger parameter to Industrial Ethernet.Open the AcquireImage function's property sheet.After restarting the PLC, it will begin scanning the vision system over CC-Link IEF Basic.Ĭonfigure the In-Sight Vision System to Receive Image Acquisition Triggers.Accept all parameter dialogs and downloads the project to the PLC.Select the PLC memory used to store the synchronized CC-Link IEF Basic registers.Add the vision system to the link scan list, and selects the desired number of stations (1-16) to scan on the vision system.Click on the Network Configuration Setting button to open the CC-Link IEF Basic Configuration dialog.Check the Use the CC-Link IEF Basic checkbox.Click on the Built-in Ethernet Port Setting tab and presses the CC-Link IEF Basic Setting button.Open the Mitsubishi GX Works 2 software to connect their PLC to the In-Sight vision system.Restart the In-Sight vision system, and the CC Link IE Field Basic protocol will be enabled upon completion of the power cycle.In the Industrial Ethernet Protocols section of the dialog, select CC-Link IE Field Basic.From the Sensor menu, open the Network Settings dialog. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |